TA Triumph-Adler P-C3565i MFP - Manual (Page 143)

8-7
Fax Settings > Default fax settings
Transmission
Item Description
Local FAX Name Register the local FAX name printed in the transmit terminal identification (TTI) area.
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (Fax Setup) (page 2-7)
Local FAX ID Register the local FAX ID.
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (Fax Setup) (page 2-7)
NOTE: The Local FAX ID is used for transmission limit purposes.
Transmission Restriction (page 8-10)
Local FAX Number Register the local FAX number printed in the transmit terminal identification (TTI) area.
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (Fax Setup) (page 2-7)
TTI The transmit terminal identification (TTI) is the information about the sending machine (transmit
terminal) that is printed by the receiving machine on the received fax. The information includes
the date and time of transmission, number of pages sent, name and fax number. This machine
enables the user to select if the TTI is printed out on the fax on the receiving system. Regarding
the location of the information to be printed, you can select inside or outside of the page image
being sent.
Value : Off, Outside, Inside
NOTE: Normally, the Local FAX Name is printed in the transmit terminal identification (TTI).
However, when job accounting has been enabled, and you send originals after entering an
Account ID, the Account Name is printed.
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (Fax Setup) (page 2-7)
Account Name Use Select whether or not to use account name as local FAX name.
Value : Off, On
Dialing Mode (Inch version
only) Select the telephone line according to the type you are contracted with. Please note that
selecting a wrong telephone line will prevent you from sending fax.
Value : Tone(DTMF), Pulse(10PPS)
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (Fax Setup) (page 2-7)
Retry Times The number of retry times can be changed automatically.
Value : 0 - 14
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (Fax Setup) (page 2-7)
ECM TX Set whether ECM TX is performed.
ECM is a communication mode specified by the ITU-T (International Telecommunication Union)
that retransmits data when an error occurs. Fax machines that have ECM mode check for
errors as they communicate, preventing distortion of the image due to noise on the line and
other conditions.
Value : On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly longer than
when [Off] is selected.
TX Start Speed Set the TX Start Speed.
When communication conditions are bad, the fax may not be transmitted correctly. In that case,
set a lower TX Start Speed.
Value : 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.