PLANET WFT-201 - Manual (Page 10)

8
4.1.3 Configure the Intelligent WFT-20x
4.1.3.1 Main Menu
The main menu shows the setting of the File, General Configuration, System Configuration,
Device Configuration, SNMP Configuration and Device Status.
4.1.3.2 Files
To set the Software Reboot, Factory Reset and Image Update.
4.1.3.2.1 Software Reboot
After configuring the software, you need to reboot the device by pressing the Software
Reboot to change the setting.
4.1.3.2.2 Factory Reset
This function is to set the device back to the factory default setting in case of the messy
setting.
4.1.3.2.3 Image Update
The section is to set the TFTP Server IP Address first, and the default address was set
to "192.168.1.2". The Image File can be updated by uploading the image file from the
TFTP server.

NOTE:
The content of the image file will write the whole firmware
of the management module, please be sure that the image
file is correct.
EM-WFT20xv1.indd 2004/11/5, �� 12:01 8