PLANET ICA-HM830W - Manual (Page 63)

3B
Appendix A: Reset Factory Default Settings
There is a button hidden in the pinhole near to the Mic. This button is used to restore the all factory
default settings. Sometimes restarting the Internet Camera will make the system back to a normal
state. However, if the system still got problems after restart, user can restore the factory default
settings and install it again.
Restore the Internet Camera:
1. Unplug the power jack to turn of the power of ICA-HM830W.
2. Insert a pin into the reset hold a s indicated with orange in the below figures. Sense a button
and keep it pressed until instructed to release.
3. Plug in the power jack to turn ICA-HM 830W, in about 20 seconds t he LED indicator will be
flashing.
4. Release the button. (Remove the pin form the reset hold)
5. The ICA-HM830W could now back to factory default. Have an access to the Internet Camera
by changing to the attempt IP address from the default 192.168.0.20.
NOTE:
Restoring the factory default setting will lose the all previous settings included IP
address forever. User needs to run the PLANET IPInstaller program to search the unit
and configure it to let the Internet Camera work properly again.