PLANET WNRT-633 - Manual (Page 62)

User’s Manual of WNRT-633
-55-
Country Select your region from the pull-down list.
This field specifies the region where the wireless function of the Router
can be used. It may be illegal to use the wireless function of the Router
in a region other than one of those specified in this field. If your country
or region is not listed, please contact your local government agency for
assistance.
Band Select the desired mode. Default is “2.4GHz (B+G+N)”. It is strongly
recommended that you set the Band to “2.4GHz (B+G+N)”, and all of
802.11b, 802.11g, and 802.11n wireless stations can connect to the
WNRT-633.
 2.4 GHz (B): 802.11b mode, rate is up to 11Mbps
 2.4 GHz (G): 802.11g mode, rate is up to 54Mbps
 2.4 GHz (N): 802.11n mode, rate is up to 300Mbps(2T2R)
 2.4 GHz (B+G): 802.11b/g mode, rate is up to 11Mbps or 54Mbps
 2.4 GHz (G+N): 802.11g/n mode, rate is up to 54Mbps or 300Mbps
 2.4 GHz (B+G+N): 802.11b/g/n mode, rate is up to 11Mbps,
54Mbps, or 300Mbps
Mode There are four kinds of wireless mode selections:
 AP
 Client
 WDS
 AP+WDS
If you select WDS or AP+WDS, please click “WDS Settings” submenu
for the related configuration. Furthermore, click the “Multiple AP”
button to enable multiple SSID function.
Channel Width You can select 20MHz or 40MHz.
Control Sideband You can select Upper or Lower.
Channel Number You can select the operating frequency of wireless network.
Data Rate Set the wireless data transfer rate to a certain value. Since most of
wireless devices will negotiate with each other and pick a proper data
transfer rate automatically, it’s not necessary to change this value
unless you know what will happen after modification.
Default is “Auto”.