Enterasys Networks 2G4072-52 - Manual (Page 22)

The 2G4072-52
1-2 Introduction
The 2G4072-52
This section provides an overview of the Enterasys Matrix N SA 2G4072‐52. For
information about software features of the 2G4072‐52 and how to configure them, refer to
the Enterasys Matrix N Standalone Series Configuration Guide.
2G4072-52
The Enterasys Matrix N SA 2G4072‐52 has 48, 10/100/1000BASE‐T/‐TX compliant ports,
through fixed front panel RJ45 connectors and 4 Mini‐GBIC ports, as shown in Figure 1‐1 .
Each of the fixed front panel ports can operate in either half‐duplex or full‐duplex mode
which can be determined by either auto‐negotiation or manual configuration.
Enterasys Matrix N SA 2G4072‐52 ports can be configured to control traffic by limiting its
rate and prioritizing it to expedite higher priority flows through the device.
Figure 1-1 2G4072-52 Front Panel
Connectivity
Depending on how the 2G4072‐52 is configured, it can support up to 48, 10BASE‐T/
100BASE‐TX switched ports connected through the front panel connectors.
Management
Management of the device can be either in‐band or out‐of‐band. In‐band remote
management is possible using Telnet, Enterasys Networks’ NetSight
® management
application, or WebView™ application. Out‐of‐band management is provided through
the RJ45 COM (Communication) port on the front panel using a VT100 terminal or a
VT100 terminal emulator.
Switch Configuration Using WebView
Enterasys Networks’ HTTP‐based Web management application (WebView) is an
intuitive web tool for simple management tasks.
RESET
CONSOLE
CPU
PWR GROUP
SELECT
GROUP 3
GROUP 2
GROUP 1
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20
2G4072-52