Dimm replacement procedure – Enterasys Networks 2G4072-52 User Manual
Page 63
Memory Locations and Replacement Procedures
N Standalone Series Installation Guide B-5
DIMM Replacement Procedure
If the DIMM is defective and must be replaced, the following sections explain how to
remove and install the DIMM. If you have questions concerning the replacement of the
DIMM, contact Enterasys Networks.
Removing the DIMM
To remove the existing DIMM, proceed as follows:
1.
Follow steps 1 through 3 as instructed on (
2.
Locate the DIMM connector on the motherboard as shown in
.
3.
Push the connector arms away from the DIMM, as shown in
, and
simultaneously lift the DIMM enough to release it from the connector fingers.
Figure B-3 Removing the Existing DIMM
4.
Rotate the DRAM SIMM upwards, then remove it from the connector fingers.
1 Connector arms
2 DIMM
3 Connector fingers
Б
3835_00_14
1
1
В