Enterasys Networks 2G4072-52 - Manual (Page 41)

Connecting to the COM Port for Local Management
N Standalone Series Installation Guide 3-15
4. Turn on the terminal and access the Setup Directory. Set the following parameters:
When these parameters are set, the Local Management password screen will display.
Refer to the Enterasys Matrix N Standalone Series Configuration Guide for further
information.
Figure 3-13 Connecting a VT Series Terminal
Connecting to a Modem
To connect a modem to the device COM port ( Figure 3‐14 ), use a UTP cable with RJ45
connectors and an optional RJ45‐to‐DB25 male adapter, and proceed as follows:
1. Connect the RJ45 connector at one end of the cable to the COM port of the module.
2. Plug the RJ45 connector at the other cable end into the RJ45‐to‐DB25 modem adapter.
3. Connect the RJ45‐to‐DB25 adapter to the communications port on the modem.
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
1 UTP cable with RJ45 connectors 3 RJ45-to-DB25 VT adapter
2 RJ45 COM port 4 VT series terminal
RESET
CONSOLE
CPU
PWR
GROUP
SELECT
GROUP 3
GROUP 2
GROUP 1
Б В А Г