Enterasys Networks 2G4072-52 - Manual (Page 44)

Completing the Installation
3-18 Installation
Completing the Installation
After installing the Enterasys Matrix N SA 2G4072‐52 and making the connections to the
network, access the device management startup screen from your PC, terminal, or modem
connection as described in the following section.
Log-In Using a Console Port Connection
Start the Command Line Interface (CLI) from the device’s local console port as follows:
1. Connect a terminal to the local console port as described in “ Connecting to the COM
Port for Local Management ”on page 3‐13. The startup screen, Figure 3‐15 , displays.
Modem Port Adapter Wiring and Signal Diagram
RJ45 DB25
Pin Conductor Pin Signal
1 Blue 2 Transmit (TX)
2 Orange 8 Data Carrier Detect (DCD)
4 Red 3 Receive
5 Green 7 Ground (GRD)
6 Yellow 20 Data Terminal Ready (DTR)
8 Gray 22 Ring Indicator
RJ45 Connector (Female)
Pins
8 1
Pins
DB25 Connector (Male)
13 1
25 14
Note: This procedure applies only to initial log-in and to logging in to a device not yet
configured with administratively-supplied user and password settings.
By default, the Matrix N Standalone Series device is configured with three user login
accounts: ro for Read-Only access; rw for Read-Write access; and admin for super-user
access to all modifiable parameters. The default password is set to blank (carriage return).
For information on changing these default passwords, refer to Chapter 3 in the
Enterasys
Matrix N Standalone Series Configuration Guide .