Datavideo RMC-180 Mark II PTZ Camera Controller - Manual (Page 18)

18
OFF
FN6 SCREEN MODE MIRROR
H+V
H
V
OFF
FN7 MEMORY SPEED SPD 1-18
FN8 TALLY LED MODE
TALLY USER
TALLY OFF
TALLY RED
TALLY GREEN
TALLY INPUT
FN9 R/B Gain Adj
R-G 00-FF (HEX)
B-G 00-FF (HEX)
WBAL. is not Manual
FN10 Shutter Adj
PTC-280: 1/25 – 1/10000
PTC-140: 1/25 – 1/10000
PTC-150: 1/25 – 1/1250
FN11 FIRMWARE VER. Version X.X
FN12 CAM INFO.
VENDOR ID XXXX
MB VER XX.XX
FPGA VER XXX
MOTOR VER XX.XX
FN13 Backlight Adj
0
25
50
75
100
FN14 Advanced Mode
ON
OFF
FN1. EXIT
Exits the setup menu mode.
FN2. CAM ADDRESS
The camera address range is from 81 to 87.
Note : The camera address setting must match the VISCA ID setting of the Block/PTZ camera’s DIP
switch. For example, VISCA ID 1 corresponds to the camera address 81. See the corresponding user
manuals for more information setting your cameras.
FN3. JOYSTICK DIR
FN3 sets the PAN and TILT directions.
PAN toggles the camera pan direction between NORMAL and REVERSE.
TILT toggles the camera tilt direction between NORMAL and REVERSE.
Note : An ERROR message will be displayed if the device fails to detect any camera device.