Datavideo RMC-180 Mark II PTZ Camera Controller - Manual (Page 28)

28
8. Press the MENU key to start the bootloader upgrade and do not disconnect the power before
the upgrade is complete.
9. After the bootloader is upgraded, the LCD panel will show the following and the user may
proceed to upgrading the application firmware.
10. Remove bootcode.bin from the RMC-180 MARK II and copy and paste the application firmware
into the device
11. Reboot the RMC-180 MARK II again and the LCD panel should show the following.
12. The RMC-180 MARK II is now ready for controlling the connected cameras.