Datavideo RMC-180 Mark II PTZ Camera Controller - Manual (Page 29)

29
8. Frequently-Asked Questions
This section describes problems that you may encounter while using RMC-180 MARK II. If you have
any questions, please refer to related sections and follow all suggested solutions. If problem still
exists, please contact your distributor or the service center.
No. Problems Solutions
1. Press the CAM OSD button to open the
OSD menu of the Sony Z280 camcorder
mounted on the PTR-10/10T MARK II but
the menu does not work. Accidentally pressing the PTC/PTR OSD
button while the OSD menu of the Sony
Z280 is open will result in the OSD menu
not working properly. To solve this issue,
manually close the Sony Z280’s OSD menu
then reopen it.
2. Menu functions such as R/B gain and
shutter speed adjustments shown on the
LCD screen work properly but the values
are not shown. This problem only occurs when controlling
the Sony Z280 camcorder mounted on the
PTR-10/10T MARK II from the RMC-180
MARK II.
3. When controlling the Sony Z280 camcorder
mounted on the PTR-10/10T MARK II from
the RMC-180 MARK II, as I adjust the iris
value after the shutter, it is still the shutter
value that is changing. After the shutter is adjusted, wait till the
dialog box disappears before proceeding to
adjusting the iris or else it will still be the
shutter value that is changing.
Note: This problem only occurs when
controlling the Sony Z280 camcorder
mounted on the PTR-10/10T MARK II from
the RMC-180 MARK II.