Datavideo RMC-180 Mark II PTZ Camera Controller - Manual (Page 20)

20
The Tally Input mode is selected when the RMC-180 MARK II is connected to the tally output of a
compatible Datavideo Switcher such as the SE-500HD or SE-650. For example, when the SE-500HD
or SE-650 Switcher is sending camera A’s video to the program output, the RMC-180 MARK II’s
channel A tally LED will be turned ON.
FN9. R/B Gain Adj
FN9 allows the user to manually adjust the white balance setting. Press the MENU dial to open the
OSD menu on the LCD display then browse to the R/B Gain Adjustment mode (FN9). Finally, adjust
the R and B levels using the SELECT/ENTER dials and push the dial to apply the new settings.
Note: The R Gain and B Gain values range from 00-FF (Hex number).
“ WBAL. Is not Manual ” will be displayed on the LCD panel if the manual white balance mode is
disabled.
FN10. Shutter Adj
This allows you to select the appropriate shutter speed for the selected camera from the list below.

PTC-280: 1/25 – 1/10000

PTC-140: 1/25 – 1/10000

PTC-150: 1/25 – 1/1250
You can also adjust the shutter speed using the IRIS/SHUTTER dial. See the IRIS/SHUTTER dial
descriptions for more information.
FN11. FIRMWARE VER.
FN11 displays the version of firmware installed on the RMC-180 MARK II.
FN12. CAM INFO.
FN12 displays camera information such as Vendor ID, mainboard firmware version, FPGA version,
and motor version.
FN13. Backlight Adj
FN13 adjusts the brightness of channel preset buttons (shown below) ONLY . The five brightness
values are 0 (darkest), 25, 50 (default), 75 and 100 (brightest).