Pioneer Elite VSX-LX305 9.2-Channel Network A/V Receiver - Manual (Page 130)

130
Setup
Multi Zone Multi Zone
„
Zone 2
Change the settings for Zone 2.
‰ Output Level (Default Value: Fixed)
Select whether to adjust the volume on the integrated amplifier in the separate
room or on this unit when outputting to Zone 2.
Fixed To adjust on the integrated amplifier in the separate room
Variable To adjust on this unit
‰ Volume Limit (Default Value: Off)
Set the maximum value for Zone 2 to avoid too high volume. Select "Off" or a
value between "-32 dB" and "+17 dB".
‰ Power On Level (Default Value: Last)
Set the Zone 2 volume level of when this unit is turned on. Select a value from
"Last" (Volume level when the unit was turned off), "-∞ dB", and "-81.5 dB" to
"+18.0 dB".
• You cannot set a higher value than that of "Volume Limit".
‰ Bass (Default Value: 0 dB)
Adjust the volume of the bass for Zone 2. Select a value between "-10 dB" and
"+10 dB".
‰ Treble (Default Value: 0 dB)
Adjust the volume of the treble for Zone 2. Select a value between "-10 dB" and
"+10 dB".
‰ Balance (Default Value: 0)
Set the left-right balance for Zone 2. Select a value between "L + 10" to
"R + 10".
‰ Sound Check (Default Value: -)
Output test tones to ZONE 2 to enjoy audio in a separate room (ZONE 2) in
addition to the main room.
Press ENTER while "Start" is being displayed. Operate by following the on
screen displays.