Pioneer Elite VSX-LX305 9.2-Channel Network A/V Receiver - Manual (Page 137)

137
Setup
Manual MCACC
Height 1 Left, Height 1 Right, Height 2 Left, Height 2 Right, Surr Back
Right, Surr Back Left:
After selecting the speaker frequency from between "63 Hz" and "16 kHz" with
the cursors / , adjust the volume of that frequency between "-12.0 dB" and
"+12.0 dB" with / . To readjust the overall volume balance with "Trim", select
"Trim" in / , and use / to adjust the volume.
• If "OVER!" is displayed during adjustment, the volume of the frequency band
or another frequency band is too high, so reduce the volume of the frequency
bands until the display disappears.
• "63 Hz" can only be selected when this speaker is set to "Large" in "System
Setup" - "Speaker" - "Crossover".
• Depending on the use of the ZONE speakers, it may not be possible to select
this setting.
• If an item cannot be selected even though connection is correct, check
that the settings in "System Setup" - "Speaker" - "Configuration" - "Speaker
Channels" matches the number of connected channels.
Subwoofer:
After selecting the speaker frequency from between "31 Hz" and "250 Hz" with
the cursors / , adjust the volume of that frequency between "-12.0 dB" and
"+12.0 dB" with / . To readjust the overall volume balance with "Trim", select
"Trim" in / , and use / to adjust the volume.
• If "OVER!" is displayed during adjustment, the volume of the frequency band
or another frequency band is too high, so reduce the volume of the frequency
bands until the display disappears.
• This cannot be selected if "No" is set in "System Setup" - "Speaker" -
"Configuration" - "Subwoofer".