Pioneer Elite VSX-LX305 9.2-Channel Network A/V Receiver - Manual (Page 136)

136
Setup
Manual MCACC
„
EQ Adjust
You can adjust the output volume of the range of each connected speaker how
you like while listening to test noises. You can adjust the volume of the different
sound ranges for each of the speakers. You can select up to 4 bands for the
Subwoofer and 9 bands for all other speakers. If the overall volume balance
changes by adjusting the volume of each frequency, you can readjust the
balance in "Trim".
‰ Front Left (Default Value: 0.0 dB)
Center (Default Value: 0.0 dB)
Front Right (Default Value: 0.0 dB)
Height 1 Left (Default Value: 0.0 dB)
Height 1 Right (Default Value: 0.0 dB)
Height 2 Left (Default Value: 0.0 dB)
Height 2 Right (Default Value: 0.0 dB)
Surround Right (Default Value: 0.0 dB)
Surr Back Right (Default Value: 0.0 dB)
Surr Back Left (Default Value: 0.0 dB)
Surround Left (Default Value: 0.0 dB)
Subwoofer (Default Value: 0.0 dB)
• The result may not be as expected depending on the input source and
listening mode setting.
Front Left, Front Right:
After selecting the speaker frequency from between "63 Hz" and "16 kHz" with
the cursors / , adjust the volume of that frequency between "-12.0 dB" and
"+12.0 dB" with / . To readjust the overall volume balance with "Trim", select
"Trim" in / , and use / to adjust the volume.
• If "OVER!" is displayed during adjustment, the volume of the frequency band
or another frequency band is too high, so reduce the volume of the frequency
bands until the display disappears.
• "63 Hz" can only be selected when this speaker is set to "Large" in "System
Setup" - "Speaker" - "Crossover".
Center, Surround Right, Surround Left:
After selecting the speaker frequency from between "63 Hz" and "16 kHz" with
the cursors / , adjust the volume of that frequency between "-12.0 dB" and
"+12.0 dB" with / . To readjust the overall volume balance with "Trim", select
"Trim" in / , and use / to adjust the volume.
• If "OVER!" is displayed during adjustment, the volume of the frequency band
or another frequency band is too high, so reduce the volume of the frequency
bands until the display disappears.
• "63 Hz" can only be selected when this speaker is set to "Large" in "System
Setup" - "Speaker" - "Crossover".
• If an item cannot be selected even though connection is correct, check
that the settings in "System Setup" - "Speaker" - "Configuration" - "Speaker
Channels" matches the number of connected channels.