Pluto Trigger - Manual (Page 10)

3 Q
UICK
S
TART
G
UIDE
3.1 P
LUTO
S
ETUP
Use the following workflow to get started:
1. Connect the 2.5mm headphone stereo plug to the Pluto Trigger camera
port located next to its USB port. Connect the camera plug to the
camera shutter release port. You may want to consult your camera user
manual on where the shutter release port is located.
2. Turn Pluto Trigger on by sliding the power switch to the right. The Status
Led should blink for three times, indicating system starts.
3. Make sure Bluetooth on Pluto Trigger is turn on. Bluetooth is on by default.
But if it was turned off accidentally, you can toggle the Bluetooth state
by pressing and hold the shutter release button on Pluto Trigger for 5
seconds. When Status Led emits three short blinks, Bluetooth is turned on,
while one long blink means Bluetooth is turned off.
3.2 C
AMERA
S
ETUP
Your camera may also require a minor set up process prior to using the
Pluto Trigger. We recommend the following camera settings to get the
most out of your Pluto Trigger:
1. Turn your camera on.
2. Set your camera to Manual Exposure mode unless recommended
otherwise.
3. Set your camera to Manual Focus mode unless recommended
otherwise.