Pluto Trigger - Manual (Page 36)

Shutter Pulse Time setting depends a lot on what device your want to
trigger. For speed flash, a shot pulse works fine. For normal cameras, 150ms
is adequate. If that is not enough to trigger you camera, choose longer
time.
8.1.3 T
RIGGER
R
ESET
T
IME
Default: 3"
Trigger Reset Time is very important in those sensor trigger modes. It
determines how often the trigger can be fired. The default value is 3”,
which means the trigger will not fire in the 3” period after trigger fires. Using
this setting, you can purposely ignore some unwanted trigger event (like
camera shutter sound), and also set the minimum trigger interval.
8.2 I
NFRARED
Pluto Trigger can control your camera via infrared. Many popular camera
brands are supported. For some camera models, you can even start/stop
video recording using infrared signal. For cameras without shutter release
port, infrared control can be a good option. And this makes Pluto Trigger
support many more cameras.
8.2.1 IR R
EMOTE
M
ODE
Default: Off
Use this setting to make Pluto Trigger emit different type of infrared signal.
Available options are: Off, Single, 2S and Video. Certain mode may not
work, depending on the setting “Camera Brand” below.
Brand Single 2S Video
Canon   
Nikon 
Sony   