Pluto Trigger - Manual (Page 31)

11. Calibrate the “Drop 2 Delay” to make Drop 2 collide with Drop 1 at
appropriate height. The auto calibration procedure is similar to that of
“Flash Delay”.
12. When all parameters are OK, you just press the “Start” button to take
photos.
Now, you can start to play with different liquid, color background and
lighting.
5.7 A
UX
Aux mode is for DIYers. You can add other sensors that are not included in
Pluto Trigger, such as ultrasonic sensor, smoke sensor or temperature
sensor.
You will need a 2.5mm audio cable to connect your DIY sensor to the Aux
port of Pluto Trigger. The tip of the cable connector is 3.3V and the base
sleeve is Ground. Pluto Trigger just samples the signal that is fed into the
middle sleeve of the connector. Please make sure the voltage of this input
signal is in the range of 0-3.3V.
5.8 F
USION
Fusion mode is more advanced. It lets you combine the sensors available
to make it suitable for your special use case.
You have the Fusion method of “AND” and “OR” to combine the sensors.
You have to set the parameters of each sensor in its own Mode.
6 S
MART SENSORS
“Smart sensors” use various sensors on your smart phone to trigger your
camera.