HP 9000 V2600 SCA - Manual (Page 103)

Chapter 5 81
Configuration utilities
ts_config
Configure the scub_ip address
Step 1. Select the desired node from the list of available nodes.
Step 2. In the ts_config display panel, select “Actions” and then “Configure
‘scub_ip’ address,” as shown in Figure 35.
Figure 35 ts_config “Configure ‘scub_ip’ address” selection
ts_config checks the scub_ip address stored in NVRAM on the SCUB
in the node. This would initially be the default address set at the factory.
If the scub_ip address is correct, the panel shown in Figure 36 is
displayed and no action is required. If the node is not detected and
scanned by
ccmd , ts_config may ask you to try again later. The ccmd
detection scan process should take less than a minute.
Figure 36 ts_config “SCUB OK” panel
Step 3. If prompted by ts_config (as indicated by the panel in Figure 37), click
“Yes” to correctly set the scub_ip address.