HP 9000 V2600 SCA - Manual (Page 94)

72 Chapter 5
Configuration utilities
ts_config
ts_config
ts_config [-display display name]
Any V2500/V2600 nodes added to the SSP must be configured by
ts_config to enable diagnostic and scan capabilities, environmental
and hard-error monitoring, and console access.
Once the configuration for each node is set, it is retained when new SSP
software is installed.
ts_config tasks include:
• Configuring a node—Adding and removing a node to the SSP
configuration
• Configuring the terminal mux—Configuring and removing the
terminal mux on the SSP
• Installing a node—Upgrading JTAG firmware, configuring a node
scub_ip address, and resetting a node
• Configuration of Multiple-node complex—Configuring V2500/V2600
nodes into a single complex and splitting V2500/V2600 nodes out of a
multiple-node complex.
• Operational support—Resetting a V2500/V2600 node or multiple-
node complex and starting console sessions.
The user must have root privilege to configure a node or the terminal
mux, because several HP-UX system files are modified during the
configuration.
Starting ts_config
To start ts_config from the SSP desktop, click on an empty area of the
background to obtain the Workspace menu and then select the
ts_config (root) option. Enter the root password.
To start ts_config from a shell (local or remote), ensure that the
DISPLAY environment variable is set appropriately before starting
ts_config .