Reset the node – HP 9000 V2600 SCA User Manual
Page 104
Advertising
82
Chapter 5
Configuration utilities
ts_config
Figure 37
ts_config
scub_ip address configuration confirmation
Step 4. A panel as the shown in Figure 38 appears confirming that the scub_ip
address is set. Click OK.
Figure 38
ts_config
scub_ip address set confirmation panel
Initiate a node reset to activate the new scub_ip address.
Reset the Node
Step 1. Select the desired node from the list of available nodes.
Step 2. Select “Actions,” then “Reset Node.” This is indicated in Figure 39.
Advertising
This manual is related to the following products: