HP 9000 V2600 SCA - Manual (Page 133)

Chapter 5 111
Configuration utilities
Configuration utilities
NOTE If there is a node_#.pwr file that is older than the node_#.cfg file, existing
node configuration files do not need to be updated.
report_cfg
This utility generates a report summarizing the configuration of all
nodes/complexes specified on the command line. The format of
report_cfg is as follows:
report_cfg [<node id|complex> [<node id|complex> ...]]
node id may be a node number, IP name, or “all.” If no node ID is
specified, the utility defaults to all nodes in the current complex.
One or more of the options in Table 12 must be specified:
Table 12 report_cfg options
If the report_cfg tool detects any nodes of complexes that contain SCA
DIMMS and some memory boards that are not populated with STACS, it
generates a report.
Example configuration report:
The system inventory has determined that you’ll need to order 8 SCA Upgrade Kits
in order to connect this cabinet with other SCA cabinets. These upgrade kits are
available by additionally ordering opt. 010 of the required SCA HyperLink product
(A5518A or A5519A). You may also have to order additional memory DIMMs, memory
boards and or processor boards to meet the minimum requirements for a SCA
configuration. Refer to the HP 9000 V-Class Ordering Guide for details.
-d Show all details
-s Show summary only
-a Show summary and details (same as -d and -s)
-A Show ASIC detail
-i Show I/O detail
-m Show memory detail
-p Show processor detail