Henny Penny HCS-2 - Manual (Page 23)

Model HCS-2,HCW-3/HCW-5/HCW-8
2-18. WATER PAN HEATER 1. Remove electrical power supplied to the cabinet.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the heater cover plates.
3. Remove the heater wires from the wire nuts. Check across the
wires of each heater with an ohmmeter. Each heater should
have a reading of 42 ohms for 208 volts and 52 ohms for 230
volts. If a heater checks defective, replace it by continuing with
this procedures.
4. Using pliers or vise grips, pull the heater from the unit.
5. Install the new heater in reverse order.
6. Replace the heater cover plates.
7. Turn on the power at the breaker box.
103 2-15
Step 2
Step 3