Henny Penny HCS-2 - Manual (Page 25)

Model HCS-2,HCW-3/HCW-5/HCW-8
2-20. LIGHT SOCKET 1. Remove electrical power supplied to the cabinet.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
Light bulbs and glass may be hot - severe burns could
result.
2. Remove the glass panel and the light bulb.
3. Remove the four screws located at the bottom of the light box.
4. The light box can be pulled down by slightly spreading the
ceiling panel sides.
5. Remove the electrical wires from the socket.
6. Remove the two screws holding the socket to the light box.
7. Install a new light socket in reverse order.
8. Turn on the power at the breaker box.
2-21. HIGH LIMIT 1. Remove electrical power supplied to the cabinet.
SWITCH
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove control end panel.
103 2-17
Step 3