Hitachi PJ-LC9 - Manual (Page 14)

12
Preparations
Adjusting the projector’s elevator
You can use the elevator feet to make adjustments if the surface on which you
need to set the projector is uneven or if you otherwise need to adjust the angle of
projection. The adjustment range of the elevator feet is 0 to 9 degrees.
1. Press and hold in the elevator buttons while holding the projector. The
elevator buttons and the elevator feet are on the both sides.
2. Raise or lower the projector to the desired height and release the elevator
buttons. When you release the elevator buttons, the elevator feet will lock into
position.
3. If necessary, you can also finely adjust the height of the projector by twisting
the elevator feet by hand.
►Do not adjust the projector’s elevator during use or
immediately after use. Handling while the projector is in a high temperature
could cause a burn and/or malfunction to the projector. Before operating, make
sure that the power switch is off, that the power cord is not plugged in, and that
the projector is cool adequately.
►If you press the elevator button without holding the projector,
the projector might crash down, overturn, smash your fingers and possibly
result in malfunction. To prevent damaging the projector and injuring yourself,
always hold the projector whenever using the elevator buttons to adjust the
elevator feet.
►Do not incline the projector rightward or leftward. Also do not incline it
backward or forward exceeding 9 degrees. Exceeding these range could cause
malfunction, and could shorten the lifetime of the consumables.
►Except for inclining by the elevator feet adjustment, place the projector
horizontally.
WARNING
CAUTION
Elevator feet Elevator button