Hitachi PJ-LC9 - Manual (Page 33)

31
ENGLISH
Multifunctional settings
With the EASY MENU, the items shown in the table below
can be performed.
Choose an item using the cursor buttons ▲/▼ on the
projector or remote control. Then perform it referring to the
following table.
EASY MENU
Item Description
ASPECT
Using the buttons ◄/► switches the mode for aspect ratio.
See the ASPECT item in the IMAGE menu. (36)
ZOOM
Using the buttons ◄/► adjusts the zoom.
See the ZOOM item in the SETUP menu. (40)
KEYSTONE
Using the buttons ◄/► corrects the keystone distortion.
See the KEYSTONE item in the SETUP menu. (40)
MODE
Using the buttons ◄/► switches the mode of picture type.
The modes of picture type are combinations of a mode of GAMMA
(33) and a mode of COLOR TEMP. (34)
Choose a suitable mode according to the projected source.
NORMAL  CINEMA  DYNAMIC
NORMAL: (COLOR TEMP = MIDDLE) + (GAMMA = #1 DEFAULT)
CINEMA: (COLOR TEMP = LOW) + (GAMMA = #2 DEFAULT)
DYNAMIC: (COLOR TEMP = HIGH) + (GAMMA = #3 DEFAULT)
• When the combination of GAMMA and COLOR TEMP differs from
pre-assigned modes above, the display on the menu for the MODE
is “CUSTOM”.
BRIGHT
Using the buttons ◄/► adjusts the brightness.
See the BRIGHT item in the PICTURE menu. (33)
CONTRAST
Using the buttons ◄/► adjusts the contrast.
See the CONTRAST item in the PICTURE menu. (33)
COLOR
Using the buttons ◄/► adjusts the strength of whole color.
See the COLOR item in the PICTURE menu. (34)
• This item can be chosen only for a video signal.
TINT
Using the buttons ◄/► adjusts the tint.
See the TINT item in the PICTURE menu. (34)
• This item can be chosen only for a video signal.
EASY MENU
ASPECT
ZOOM
KEYSTONE
MODE
BRIGHT
CONTRAST
COLOR
TINT
SHARPNESS
WHISPER
MIRROR
RESET
FILTER TIME
LANGUAGE 4:3
+0
+0
NORMAL
+0
+0
+0
+0
+3
NORMAL
NORMAL
EXECUTE
0h
ENGLISH
Go To Advance Menu...