Hitachi PJ-LC9 - Manual (Page 19)

17
ENGLISH
Preparations
Loading batteries into the remote control
1. Remove the battery cover. Slide back and remove the
battery cover in the direction of the arrow.
2. Take old batteries out and/or put new batteries in. When
putting in batteries, align and insert the two AA batteries
according to their plus and minus terminals as indicated in
the remote control.
To use the remote control, please load the batteries. Whenever the remote control
starts to malfunction, replace the batteries. If you will not use the remote control
for an extended period, remove the batteries from the remote control and store
them in a safe place.
►Always handle the batteries with care and use them only as
directed. Improper use may result in battery explosion, cracking or leakage,
which could result in fire, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specified. Do not use batteries of different
types at the same time. Do not mix a new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a
battery.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
• Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry
place.
• Do not give the battery a physical impact.
• If you observe a leakage of a battery, wipe out the liquid and then replace
a battery. If the liquid adheres to your body or clothes, rinse well with water
immediately.
• Obey the local laws on disposing a battery.
WARNING
3. Close the battery cover. Replace the battery cover in the
direction of the arrow and snap it back into place.