Hitachi PJ-LC9 - Manual (Page 46)

44
Multifunctional settings
With the OPTION menu, the items shown in the table
below can be performed.
Choose an item using the cursor buttons ▲/▼ on the
projector or remote control, and press the cursor button ►
on the projector or remote control, or the ENTER button
on the remote control to execute the item. Then perform it
referring to the following table.
OPTION menu
Item Description
AUTO SEARCH
Using the buttons ▲/▼ turns on/off the automatic signal search
function.
TURN ON  TURN OFF
When the TURN ON is selected, detecting no signal automatically
cycles through input ports in the following order.
RGB  S-VIDEO  VIDEO
Then when an input is found, the projector will stop searching and
display the image.
AUTO OFF
Using the buttons ▲/▼ adjusts the time to count down to
automatically turn the projector off.
Long (max. 99 minutes)  Short (min. 0 minute = DISABLE)
When the time is set to 0, the projector is not turned off
automatically. When the time is set to 1 to 99, and when the passed
time with a no-signal or an unsuitable signal reaches at the set
time, the projector lamp will go off and the power indicator begins
blinking. Please refer to the section “Turning off the power”. (20)
LAMP TIME
The lamp time is the time counted after the last resetting. It is
shown in the OPTION menu as the usage time of the lamp.
Performing this item resets the time.
Pressing the RESET button on the remote control or the button ►
on the projector displays a dialog to make sure.
To perform reset, point at RESET using the button ▲.
RESET  CANCEL
• Please reset the lamp time only when you have replaced the lamp,
for a suitable indication about the lamp.
• For the lamp replacement, please see the section "Lamp".
(47, 48, 49)
LAMP TIME
0h.
RESET
CANCEL
AUTO OFF
ENABLE
10min.
AUTO OFF
DISABLE
0min.
MENU [RGB] :SELECT
AUTO SEARCH
AUTO OFF
LAMP TIME
FILTER TIME
SERVICE TURN OFF
0min
0h
0h
PICTURE
IMAGE
INPUT
SETUP
SCREEN
OPTION
EASY MENU