Hitachi PJ-LC9 - Manual (Page 18)

16
Preparations
Connecting power supply
1. Connect the connector of the power cord to the AC inlet of the
projector.
2. Firmly plug the power cord's plug into the outlet.
Before connecting, make sure that the power switch is the OFF
position (pressed the side marked “O”).
►Please use extra caution when connecting the power cord as
incorrect or faulty connections may result in fire and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, contact
your dealer to newly get correct one.
• Only plug the power cord into an outlet rated for use with the power cord's
specified voltage range.
• Never modify the power cord. Never attempt to defeat the ground connection
of the three-pronged plug.
• The power outlet should be close to the projector and easily accessible.
• Do not touch the power cord with a wet hand.
• Check that the connecting portion of the power cord is clean (with no dust)
before using. Use a soft and dry cloth to clean the power plug.
• Insert the power plug into a power outlet firmly. Avoid using a loose, unsound
outlet or contact failure.
WARNING
Power switch
AC inlet
Connector of the power cord