Contact image sensor removal (continued) – HP 1100AHP User Manual
Page 70
Advertising
68 Removal and Replacement
C4224-90962
Contact image sensor removal (continued)
Figure 4-5
Removing the Contact Image Sensor (continued)
2
Gently pry open the snap connectors on each end of the Contact Image Sensor with a
small flat-blade screwdriver.
3
Rotate the unit up, grasp the CIS on each end, pry the end pin out of the plastic frame,
and slowly lift it out.
NOTE:
Be careful with the CIS when you lift it out; it has two springs and a small cable connected to it.
Advertising