HP 1100AHP - Manual (Page 85)

C4224-90962 External assemblies and covers 83
Printer laser/scanner cover removal
Figure 4-20 Removing the printer laser/scanner cover
Prior to this step: Remove the memory card (if applicable), pods, back cover, front door, front
cover, scanner, and paper guides.
1 Remove the three screws fastening the Printer Laser/Scanner Cover. Two of the screws
are shown in the photo above (callout 1). The remaining screw at the right end of the
scanner cover is not shown in the above photo.
2 Disconnect the cable from the Control Panel (callout 2).
NOTE: If the Control Panel needs to be replaced, it can be disconnected from the Printer Laser/
Scanner Cover by removing the remaining screw.
3 Using a small flat-blade screwdriver, release the plastic snaps on the left and right ends
of the Printer Laser/Scanner Cover (callout 3).