HP 1100AHP - Manual (Page 93)

C4224-90962 Internal assemblies 91
Fusing element removal
Figure 4-28 Reassembly of fusing element clips
NOTE: During reassembly, make sure the metal clips are seated properly.
The front of the metal clip has a small threaded hole. There is a corresponding hole on the
printer chassis.
Slide the front of the metal clip underneath the threaded tab on the printer chassis so that the
two holes line up.
Push down on the metal clip (you will feel the tension springs pushing against the clip) until
the small metal tab on the back of the clip snaps into place.