Hitachi SJ-FB - Manual (Page 32)

32
Chapter 7 FUNCTIONS
7.5 Compensation of secondary resistor function
(Temperature revision)
P025: Compensation of secondary
resistor selection
b098: Thermistor selection
b099: Thermistor error level
C085: Thermistor adjustment
Relation
Please use this function, if you want to do the temperature revision
to restrain the speed fluctuation by the temperature change of the
motor. (Please use the thermistor of the characteristic like type B
that shows it below. (This thermistor is the characteristic of
PE-41E made of a Shibaura electronics co.,Ltd.))
1. Please wire the thermistor that is built to the motor to the inverter.
(Wiring between TH and CM1 of the terminal unit board of the main body)
2. Please set up it as follows.
P025………01(valid) b098……… 02(NTC)
b099……….(This code is thermistor error level setting. Set the resistance value
of temperature for trip according to thermistor methods.)
C085……….(Use this as gain adjustment.)
Figure 7-7 Resistor vs. Temperature Curves
(Note):Please wire it once again after the thermistor error occurrence level is changed, after you
remove the wiring of the thermistor once, if the thermistor error occurred.