FUJITSU MHT2060BH - Manual (Page 117)

5.3 Host Commands
C141-E203-01EN 5-43
(12) STANDBY IMMEDIATE (X’94’ or X’E0’)
Upon receipt of this command, the device enters the standby mode. The device
then reports the status to the host system. This command does not support the APS
timer function.
•
Error reporting conditions
(1) A SATA communication error occurred (ST = 51h, ER = 14h).
At command issuance (Shadow Block Registers setting contents)
CM X’94’ or X’E0’
DH x x x x xx
CH
CL
SN
SC
FR
xx
xx
xx
xx
xx
At command completion (Shadow Block Registers contents to be read)
ST Status information
DH x x x x xx
CH
CL
SN
SC
ER
xx
xx
xx
xx
Error information