FUJITSU MHT2060BH - Manual (Page 173)

5.3 Host Commands
C141-E203-01EN 5-99
At command completion (Shadow Block Registers contents to be read)
ST Status information
DH x x x x xx
CH
CL
SN
SC
E
xx
xx
xx
xx
Error information
*1) Data Transfer Mode
The host sets X’03’ to the Features field. By issuing this command with setting a
value to the Sector Count field, the transfer mode can be selected. Upper 5 bits of
the Sector Count register defines the transfer type and lower 3 bits specifies the
binary mode value.
The IDD supports following values in the Sector Count field value. If other value
than below is specified, an ABORTED COMMAND error is posted.
Note: For a serial ATA device, the setting of a data transfer mode is reflected in
WORD 63 and 88 in IdentifyDevice information. However, the actual
data transfer rate depends on the serial ATA signaling rate in WORD 76 in
IdentifyDevice information.
Transfer mode Sector Count file
•
PIO default transfer mode 00000 000 (X’00’)
00001 000 (X’08’: Mode 0)
00001 001 (X’09’: Mode 1)
00001 010 (X’0A’: Mode 2)
00001 011 (X’0B’: Mode 3)
•
PIO flow control transfer mode X
00001 100 (X’0C’: Mode 4)
00010 000 (X ' 10 ' : Mode 0)
00010 001 (X ' 11 ' : Mode 1)
•
Single word DMA Mode X
00010 010 (X ' 12 ' : Mode 2)