Installation wizard setup procedure, Installation notes, Wps870g user guide – Motorola WPS870G User Manual
Page 19
WPS870G
User Guide
PAGE 12
Installation Wizard Setup Procedure
The Windows-based Installation Wizard supplied on the CD-ROM, runs on Windows 98SE,
Windows ME, Windows 2000, and Windows XP. Using this Installation Wizard is the
recommended method to configure the Print Server.
Installation Notes
The screenshots seen here may differ slightly, depending upon your version of the
Installation Wizard. However, the functionality is the same.
If using Windows XP, you may have to temporarily disable your built-in firewall so that
the Installation Wizard can operate successfully. Follow the directions here:
To configure your WPS870G using the supplied CD-ROM:
1
Insert the CD-ROM in your computer’s CD-ROM drive. The set up wizard starts
automatically.
2
Click Install and Configure the Wireless Print Server.
3
The Connect your Print Server to Your Router window is displayed. Follow the
instructions and click Next.
4
When asked for a password, type ‘motorola’.
1
Note: If the Windows set up wizard does not start automatically, do the following: Click
Start
, then Run. On the next screen, click Browse and locate your CD-ROM drive. Locate
SetupWizard.exe
and highlight it. Click Open, then OK. The set up wizard starts.