Mocomtech CRS-300 - Manual (Page 13)

CRS-300 1:10 Redundancy Switch Revision 16
Table of Contents MN/CRS300.IOM
xi
Figures
Figure 1-1. Typical Redundancy System-Level Block Diagram .............................................................. 1–5
Figure 1-2. CRS-280/280L IF Switch Operational Schematic ................................................................. 1–6
Figure 1-3. CRS-300 Front Panel ............................................................................................................. 1–7
Figure 1-4. CRS-300 Rear Panel – Configuration Example ..................................................................... 1–8
Figure 1-5. CRS-310 RMI (PL/9579-1) .................................................................................................... 1–9
Figure 1-6. CRS-320 TMI EIA-232/-422 (PL/9581-1)........................................................................... 1–10
Figure 1-7. CRS-330 TMI ....................................................................................................................... 1–10
Figure 1-8. CRS-340 TMI EIA-232/-422
or LVDS or G.703 ............................................................... 1–10
Figure 1-9. CRS-365D TMI E1 (1-4 ports) (PL/12985-2) ...................................................................... 1–10
Figure 1-10. CRS-370 TMI HSSI (PL/9034-1) ...................................................................................... 1–10
Figure 1-11. CRS-305 RMI (PL/11494-1) .............................................................................................. 1–12
Figure 1-12. CRS-306 RMI (PL/11494-2) .............................................................................................. 1–12
Figure 1-13. CRS-307 RMI (PL/11494-3) .............................................................................................. 1–12
Figure 1-14. CRS-315 TMI (PL/11493-1) .............................................................................................. 1–13
Figure 1-15. CRS-316 TMI RS422
or GigE (PL/12498-1) .................................................................... 1–13
Figure 1-16. CRS-325 TMI G.703 or ASI (PL/11492-1) ....................................................................... 1–13
Figure 1-17. CRS-335 TMI (PL/11491-1) .............................................................................................. 1–13
Figure 1-18. CRS-336 TMI HSSI
or GigE (PL/12499-1) ....................................................................... 1–13
Figure 1-19. CRS-345 TMI G.703 (4 ports) (PL/11495-1) .................................................................... 1–13
Figure 1-20. CRS-365 TMI E1 (1-4 ports) (PL/12985-1) ....................................................................... 1–14
Figure 1-21. CRS-230 System Controller (AS/0377) ............................................................................. 1–14
Figure 1-22. CRS-240 AC Power Supply (AS/0376) ............................................................................. 1–14
Figure 1-23. CRS-250 DC Power Supply (PL/10458-1) ........................................................................ 1–14
Figure 1-24. CRS-350 ESC Switch – Front Panel .................................................................................. 1–15
Figure 1-25. CRS-355 UDI ..................................................................................................................... 1–15
Figure 1-26. CRS-350 ESC Switch – Rear Panel ................................................................................... 1–15
Figure 1-27. CRS-300 Dimensional Envelope ....................................................................................... 1–19
Figure 1-28. CRS-350 Dimensional Envelope ....................................................................................... 1–19
Figure 1-29. CRS-280 (70/140 MHz) Dimensional Envelope ................................................................ 1–20
Figure 1-30. CRS-280L (L-Band) Dimensional Envelope ..................................................................... 1–21
Figure 2-1. Typical Rack Mounting Configuration .................................................................................. 2–2
Figure 3-1. Networking Loop with Switches ............................................................................................ 3–2
Figure 3-2. Networking Loop Example .................................................................................................... 3–4
Figure 3-3. Networking Loop Example (Simplified) ................................................................................ 3–4
Figure 3-4. Hub-to-Hub with Standard Traffic using Routers .................................................................. 3–6
Figure 3-5. Wired-thru for Hub-to-Hub with Standard Traffic using Routers .......................................... 3–7
Figure 3-6. Wired-around for Hub-to-Hub with Standard Traffic using Routers ..................................... 3–7
Figure 3-7. Hub-to-Remotes with Standard Traffic using Routers or Switches ....................................... 3–8
Figure 3-8. Wired-thru for Hub-to-Remotes with Standard Traffic using Routers or Switches ............... 3–9
Figure 3-9. Wired-around for Hub-to-Remotes with Standard Traffic using Routers or Switches .......... 3–9
Figure 3-10. Point-to-Multipoint using Routers ..................................................................................... 3–10
Figure 3-11. Wired-thru for Point-to-Multipoint with Routers ............................................................... 3–11
Figure 3-12. Wired-around for Point-to-Multipoint with Routers .......................................................... 3–11
Figure 3-13. Point-to-Multipoint using Switches ................................................................................... 3–12
Figure 3-14. Wired-thru, Hub-to-Remotes, Split-path Traffic using Switches (Point-to-Multipoint) .... 3–13
Figure 3-15. Wired-around, Hub-to-Remotes, Split-path Traffic using Switches (Point-to-Multipoint) ...... 3–13
Figure 4-1. Control Cable Connection Example for CRS-300 Æ CRS-280............................................. 4–5