Mocomtech CRS-300 - Manual (Page 187)

CRS-300 1:10 Redundancy Switch Revision 16
Front Panel Operation MN/CRS300.IOM
7–7
7.3 SELECT (Top-Level) Menu
SELECT: CONFIG INFO
MONITOR STORE/LD UTIL
Move the cursor to the desired choice using the ◄ ► arrow keys, then press [ENT] . The
following table describes the function of each menu branch (along with the section in this chapter
that provides information on that branch and its accompanying submenus):
Selection Sect. Menu Branch Description
CONFIG 7.4 (Configuration) Permits the User to fully configure the Switch.
INFO 7.5
(Information) Permits the User to view information on the Switch, without
having to go into configuration screens.
MONITOR 7.6
Permits the User to monitor the status of the Switch and view the log of
stored events for both the Switch and its attached modems.
STORE/LD 7.7
(Store/Load) Permits the User to store and to retrieve up to 10 different
Switch configurations.
UTIL 7.8
(Utility) Permits the User to perform miscellaneous functions, such as
setting the Real-time clock, adjusting the display brightness, etc.
7.4 SELECT: CONFIG (Configuration)
CONFIG: MANUAL AUTO[OFF]
OPTIONS REMOTE ACTIVE
Move the cursor to the desired choice using the ◄ ► arrow keys, then press [ENT] .
The submenus available under the CONFIG menu branch are as follows:
Selection Sect. Submenu Description
MANUAL 7.4.1
Permits the User to select which traffic MODEM the Switch should bridge
or backup.
AUTO
[OFF/ON]
7.4.2
Permits the User to turn Auto mode off or on. The currently selected state
is always shown on this menu
OPTIONS 7.4.3
Permits the User to set several operating parameters of the Switch that
pertain to enabling or disabling the availability of Traffic Modems, the
reporting of faults and time delays for responding to faults.
REMOTE 7.4.4 Permits the User to define the remote control settings.
ACTIVE 7.4.5 Permits the User to activate modems, if a TMI is present.
IMPORTANT
The Switch may be monitored over the remote control bus at any time.
When in Local mode, however, configuration parameters may only be
changed through the front panel. Conversely, when in Remote mode,
the unit may be monitored from the front panel, but configuration
parameters via may only be changed remote control bus.