Mocomtech CRS-300 - Manual (Page 26)

CRS-300 1:10 Redundancy Switch Revision 16
Introduction MN/CRS300.IOM
1–4
1.2 CRS-300 Compatibility
Table 1-1 shows the Comtech EF Data modems that are compatible for use with the CRS-300
1:10 Redundancy Switch.
Table 1-1. CRS-300 Compatibility Table
Modem Optional Switches
CDM-570 CRS-280 IF Switch (70/140 MHz)
CDM-570L CRS-280L IF Switch (L-Band)
CDM-600
Note 1
CRS-280 IF Switch (70/140 MHz)
CRS-350 ESC Switch (IDR Overhead)
CDM-600L
Note 1
CRS-280L IF Switch (L-Band)
CRS-350 ESC Switch (IDR Overhead)
CDM-625 Note 1
CRS-280L IF Switch (L-Band)
CRS-350 ESC Switch (IDR Overhead)
CDM-Qx
CRS-280 IF Switch (70/140 MHz)
NOTE
Up to one modulator and one demodulator allowed per CDM-Qx/QxL.
CDM-QxL
CRS-280L IF Switch (L-Band)
NOTE
Up to one modulator and one demodulator allowed per CDM-Qx/QxL.
CDM-700
CDM-710
CDM-710G
CRS-280 IF Switch (70/140 MHz)
CRS-280L IF Switch (L-Band)
SLM-5650/5650A
CRS-280 IF Switch (70/140 MHz)
CRS-280L IF Switch (L-Band)
CRS-350 ESC Switch (IDR Overhead)
Compatibility Notes:
1. The CDM-625 Open Network Satellite Modem, with its available CDM-600 Emulator Mode,
serves as an operationally transparent replacement unit for the CDM-600/600L Open Network
Satellite Modems.
2. The CiM-25, Comtech EF Data’s low-cost Internet Protocol (IP) Monitor & Control (M&C)
interface for existing CEFD modems, is not compatible for use on modems operating within a
CRS-300 redundancy system. Taking this prohibition of use under further consideration, the
CiM-25 should not, under any circumstances, be connected to the Remote port on the
CRS-300’s CRS-230 Controller card for control of the Switch and modems.