Mocomtech CRS-300 - Manual (Page 199)

CRS-300 1:10 Redundancy Switch Revision 16
Front Panel Operation MN/CRS300.IOM
7–19
7.7 SELECT: STORE/LD (Store or Load Configuration)
STORE/LOAD CONFIG:
STORE LOAD (PRESS ENTER)
Select STORE or LOAD using the ◄ ► arrow keys, then to press [ENT] . These submenus permit
the User to store or load up to 10 different Switch configurations in its non-volatile memory.
NOTE: These are configurations for the Switch itself, not the modems to which it is attached.
7.7.1 STORE/LD: STORE
STORE CONFIGURATION TO
LOCATION: 10 (ENTER)
Select the location, using the ▲ ▼ arrow keys, to where the current configuration is to be stored,
then press
[ENT] . Locations 1 through 10 are available. If the selected location does not contain a
previously stored configuration, the following display appears:
YOUR CONFIGURATION HAS
BEEN STORED! (ENTER)
Press [ENT] or [CLR] to return to the previous menu. If, however, the selected location contains a
previously stored configuration, the following display appears:
WARNING! LOC 10 CONTAINS
DATA! OVERWRITE? NO YES
Select NO or YES using the ◄ ► arrow keys, then to press [ENT] . Selecting YES will overwrite
the existing configuration at the selected location.
7.7.2 STORE/LD: LOAD
LOAD CONFIGURATION FROM
LOCATION: 10 (ENTER)
Select the location to load a configuration from, using the ▲ ▼ arrow keys, then to press [ENT] .
Locations 1 through 10 are available. If the selected location contains valid data, the following
display appears:
THE NEW CONFIGURATION
HAS BEEN LOADED (ENTER)
Press [ENT] or [CLR] to return to the previous menu. If, however, the selected location does not
contain valid data, the following screen display appears:
WARNING! LOC 10 CONTAINS
NO DATA! (ENTER)
Press [ENT] or [CLR] to return to the previous menu.