2 modem configuration, 1 modem power, 2 modem firmware and hardware requirements – Mocomtech CRS-300 User Manual
Page 146: 1 flash updating, 3 modem operational configuration, 2 modem configuration 5.2.1 modem power
CRS-300 1:10 Redundancy Switch
Revision 16
Modem, RMI/TMI, and Switch Configuration MN/CRS300.IOM
5–2
5.2
Modem Configuration
5.2.1
Modem Power
Connect the power cords of each modem to a power supply and turn all modems ON.
5.2.2
Modem Firmware and Hardware Requirements
For the CRS-300 1:10 Redundancy Switch to operate correctly, it is important that all Traffic
Modems and the Redundant Modem must be of the same model. In addition to matching
hardware requirements, the Redundant Modem must have the same software revision and
installed options so that the it can properly mimic all Traffic Modems.
Permitted modem models and firmware versions are as follows:
Modem
Modem Firmware Version
GigE Firmware Version
CDM-570 1.4.1
or
later
N/A
CDM-570L 1.3.1
or
later
N/A
CDM-Qx/QxL 1.1.4
or
later
N/A
CDM-600 1.1.5
or
later
N/A
CDM-600L 1.1.1
or
later
N/A
CDM-700
1.2.1, 1.2.4 or later
(Note: When using GigE, F/W Ver. 1.2.3 is not compatible with the CRS-300)
1.1.9
CDM-710 4.1.1
or
later
1.1.3
CDM-710G
5.1.1. or later
1.1.9
CDM-625 1.1.1
or
later
N/A
SLM5650/5650A Firmware and Hardware Requirements: In order to support the desired
redundancy, the appropriate firmware must be loaded in the SLM-5650/5650A base modem,
Network Processor (if applicable) and CRS-300. Higher versions of the firmware continue
support for the given interface (i.e. the highest version supports all interfaces); the lowest
firmware versions required to support a given interface type are shown in the following table:
Interface Type
SLM-5650
Base Modem
SLM-5650A
Base Modem
10/100/1000 Base-T
(GbE) Interface card
Network
Processor
Module
CRS-300
Serial (EIA-232/HSSI)
1.2.4 1.1.1
N/A
N/A 2.1.7
Ethernet (Single-port Ethernet Bridge Mode
using 10/100/1000 Base-T card)
1.2.4 1.1.3
1.1.2 N/A
2.1.7
Ethernet (Single-port Ethernet Bridge Mode
using Port 1 of 4-port NP Module)
1.5.1 1.1.8
N/A 1.5.1
2.1.7
5.2.2.1 Flash Updating
For detailed instructions on upgrading modem firmware via Flash Update, refer to the pertinent
modem’s Installation and Operation Manual.
5.2.3
Modem Operational Configuration
This chapter assumes user familiarity with the menu navigation and configuration parameter
selection methods using the individual modems’ front panel menu. For detailed instructions on