Moog RKP-II - Manual (Page 41)

6 Mounting Preparing for mounting
© 2010 Moog GmbH User Manual RKP-II (CA53461-001; Version 2, January 2010) 33
6 Mounting
Mounting
6.1 Preparing for mounting
Preparing for mounting
Procedure:
1. Pump has been unpacked.
Ö Chap. "5.1 Unpacking the Pump", Page 29
2. The required supplementary documentation is at hand.
3. The hydraulic plans from the machine / equipment manufacturer have
been made available.
4. The required standard tools and mounting material are at hand.
For pumps in explosive areas, the supplementary documentation should
also be observed:
Ö User Manual RKP II Explosion-Proof
For any and all tasks to be performed on the pump, suitable personal
protective equipment should be worn.
Ö Chap. "2.2.4 Work Safety", Page 9
DANGER Risk of injury and property damage as a result of leaking
operating fluid!
Any operating fluid that sprays out under high pressure
because of improper mounting may lead to serious injury or
property damage.
• Only trained personnel should be allowed to mount the
pump.
• Check the cleanliness of the mounting surface.
• Observe the tightening torques for the fasteners.
Ö Chap. "12.2 Tightening Torque", Page 63
• Use only specified fasteners (quantity/type).
• Make sure the proper flange and screws are being used
as per standard (e. g. SAE).
• Check for the existence and use of the proper O-rings.
• Use the correct sealant based on the operating fluid.
• Mount all connections to be hydraulically sealed.
• Do not exceed the maximum operating pressure in the
system.
• Do not exceed the maximum body pressure.
DANGER Serious bodily injury!
Starting-up the machine/equipment during the mounting
process may lead to serious bodily injuries or death.
• Make sure that the machine/equipment cannot be
switched on.
The pump is pre-assembled at the factory.