Moog RKP-II - Manual (Page 54)

Initial Pump Set-Up 7 Operation
46 User Manual RKP-II (CA53461-001; Version 2, January 2010) © 2010 Moog GmbH
7.1.2.3 Mechanical Stroke Adjustment
The information in the following table refers to Ö Fig. 10, Page 21
Procedure:
1. Set the adjusting screws of the mechanical stroke adjustment and
tighten them.
- Tightening torque Ö Tab. 10, Page 46
2. Secure the adjusting screws with SEAL-Lock ® sealing nuts SW 24
(M16x1.5).
- Tightening torque M
A
= 200 Nm ± 10 Nm.
3. Attach a note that the seal capacity can no longer be guaranteed after
loosening them five times.
- If required: replace SEAL-Lock ® sealing nut.
Information on stroke adjustments:
Ö Chap. "3.5.6 Mechanical Stroke Adjustment, B1", Page 21
When adjusting the required flow volume, make sure that the stroke ring is
held tight between the two adjustment screws.
Upon delivery, the pump is set to V
max.
.
Displacement V [cm 3 /U] 19 32 45 63 80 100 140
Pos.1 WS 8 = 15 Nm + 5 Nm WS 8 = 25 Nm + 5 Nm
Pos. 2 WS 24 = 200 Nm ± 10 Nm
ΔV for 1 mm adjusting screw travel
(pitch 1.5 mm/R)
3.6 5.6 6.5 8.9 11.3 11.5
Tab. 10: Mechanical Stroke Adjustment