M-S Cash Drawer 7193 - Manual (Page 94)

7193 Owner’s Guide Commands
May 1996
If you have programmed the printer to handle the busy line the old way, but wish
to re-program it to the new way, do the following steps:
1. Record the current switch settings for their RS-232C parameters.
2. Set switches 2, 3, and 6 to OFF, and set switches 1, 4, and 5 to ON.
3. Power cycle the printer.
4. Wait until the printer beeps to store the parameter change in NVRAM.
5. Restore the switches to their RS-232C parameters.
6. Power cycle the printer.
7. Print out the diagnostics to be sure that the busy line parameter changed.
Real Time Status Transmission
Transmits the selected one byte printer status specified by n in Real Time
according to the following parameters.
GS Sequence
Hex Decimal ASCII Value of n
1D 04 n 29 4 n GS EOT n 1 = Transmit printer status
2 = Transmit RS-232C busy status
3 = Transmit error status
4 = Transmit receipt paper status
The command is ignored if n is out of range.
n=2: