M-S Cash Drawer 7193 - Manual (Page 98)

7193 Owner’s Guide Commands
May 1996
DLE Sequence
Hex Decimal ASCII Value of n
10 05 n 16 5 n DLE ENQ n 1 = Recover and restart
2 = Recover and clear buffers
3 = Cancel slip waiting
The command is ignored if n is out of range.
Note: An application using the DLE sequence must send ENQ within 100
milliseconds of DLE or the printer will misinterpret the DLE and execute a
Clear Printer command. Avoid this possibility by using the GS ETX n
sequence which is handled exactly the same as DLE ENQ n.
n = 1
Restarts printing from the beginning of the line where an error occurred, after
recovering from the error. Print settings that are normally preserved from line to
line, such as character height and width, are still preserved with this command.
This sequence is ignored except when the printer is busy due to an error
condition.
If the receipt is selected, this command will attempt recovery from a knife error.
Other errors associated with the receipt, such as paper out or printhead
overheating, can be recovered from only by clearing the specific condition, such
as loading paper or letting the printhead cool down.
n = 2
Recovers from an error after clearing the receive and print buffers. Print settings
that are normally preserved from line to line, such as character height and width,
are still preserved with this command. This sequence is ignored except when the
printer is busy due to an error condition.
The same error recovery possibilities exist as for n = 1.