Multi-Tech Systems DataTalker DT101/xx - Manual (Page 128)

128
DataTalker Owner’s Manual
TYPE COMMAND DESCRIPTION
Configure #L0 Negotiate V42 Mode During Handshake
Error #L1 MNP On/LAPM Off
Correction #L2 LAPM On/MNP Off
(Section F.9) #L3 Direct LAPM/Phase Out Handshake
$A Auto-Reliable Buffering
$F Enable/Disable Auto-Reliable Fallback Character
$R Retransmit Count
$E Error Correction at 300 bps
Compression & &BS Maximum Block Size
Block Size &E14 Data Compression Disabled
(Section F.10) &E15 Data Compression Enabled
Configure Speed $BA0 Speed Conversion On
Conversion $BA1 Speed Conversion Off
(Section F.11) $MB Set modem speed (e.g.,$MB28800)
$SB Set serial port speed (e.g.,$SB115200)
Execute $H Help
Immediate I Product Code Inquiry
Action L5 List Current Operating Parameters
Commands L6 List S-Register Values
(Section F.12) L7 List Additional Configuration Parameters
L8 List On-line Diagnostics
Read and Assign Sr? Read Current S-Register Value
S-Register Values Sr= Assign S-Register Value
(Appendix E)