Multi-Tech Systems DataTalker DT101/xx - Manual (Page 86)

86
DataTalker Owner’s Manual
3 Data Port - Plug your PC into the Data/Command port and put dip switch 3 up to exit
command mode and enable data mode (located on the side of the Data Talker).
MODEM DSU/TA
DIAL-UP LEASED DIGITAL
VOICE/FAX CHANNEL 1
FXO FXS
EXTERNAL COMPOSITE
DATA/COMMAND
RS232C/V.35 E&M
INTERNAL COMPOSITE POWER
GND
DATA/COMMAND
Connector
RS232 Cable
Configuration and installation is complete.
To connect to the main office turn the Data Talker off and on. It will call the main office every
time it is powered up.
To view or change the current configurations, select option 1 from the main menu.
Press any key to continue.
Storing parameters.
Resetting unit.
Please wait 10 seconds. Then hit ENTER to display the Main Menu.