Multi-Tech Systems DataTalker DT101/xx - Manual (Page 53)

53
Chapter 4 - Unpacking and Configuration
To verify and/or change the terminal adapter’s configuration, select option 2, wait 5 seconds,
and enter AT!V to access the terminal adapter’s configuration menu. Refer to the ISDN
Terminal Adapter Owner’s Manual for configuration commands. To exit the terminal adapter’s
configuration menu, enter CTRL+X; then, to return to the DataTalker’s Composite Link
Settings - Internal TA menu, press ENTER, Q.
When you have set all the options for the terminal adapter, enter S and press ENTER to
store all configurations. Then enter P and press ENTER to return to the Configurations menu.
18 If the composite link device is an external device, verify that the configuration options meet
the conditions of your installation.
C o m p o s i t e L i n k S e t t i n g s - E x t e r n a l D e v i c e
1 - O n - L i n e X M T R a t e : 5 6 0 0 0
2 - C l o c k i n g : E x t e r n a l
3 - B a c k t o B a c k : O f f
4 - D O D / D O I : O n
5 - D O I T i m e r : 0 3 m i n
6 - D O D T o g g l e D T R : 4 0 s e c
S - S t o r e A l l C o n f i g u r a t i o n s
M - M a i n M e n u
P - P r e v i o u s M e n u
S e l e c t i o n : _
If you need to change an option, select its number from the menu.
• Set option 1, Clocking, to match the external device; i.e., if the external device supplies
clocking, set option 1 to “External.”
• Set option 2, Speed, to the same rate as the external device.
When you have set all the options for the external device, enter S and press ENTER to store
all configurations. Then enter M and press ENTER to return to the Main Menu. Enter 5 and
press ENTER to exit command mode.
19 When you have finished configuring the DataTalker, disconnect the terminal or PC from the
command port and place DIP switch position 3 in the OPEN (up) position to change the data/
command port over to a data channel.
This completes the configuration of the DataTalker. Proceed to Chapter 5, “Installation,” to cable
the DataTalker.