Multi-Tech Systems DataTalker DT101/xx - Manual (Page 103)

103
Chapter 7 - Troubleshooting
7.9 Composite Link Statistics
Table 7-9. Composite Link Statistics
Step Procedure
1 Toggle DIP switch position 3 to the down (closed) position to enable the command port.
2 Connect a terminal or PC running communications software to the DATA/COMMAND
connector on the back panel of the DataTalker.
Note: Any cables connected to the computer should be shielded to reduce interference.
3 Apply power to the DataTalker.
4 Apply power to the terminal or PC. Run the PC’s communications software in terminal mode
and press ENTER twice to establish communications with the DataTalker. The Main Menu
appears:
Main Menu
1 - Configurations
2 - Statistics
3 - Reset Options
4 - Diagnostics
5 - Exit Command Mode
6 - QUICK SETUP
Selection : _
5 Enter 2 and press ENTER. The Statistics menu is displayed:
Statistics
1 - View Composite Link Statistics
2 - Clear Composite Link Statistics
M - Main Menu
P - Previous Menu
Selection : _
6 Enter 1 and press ENTER to view the composite link statistics:
Composite Link Statistics
Elasped Time : 00 Days 00 Hours 00
Minutes
Data Blocks Transmitted : 0
Data Blocks Retransmitted : 0
Data Blocks Received : 0
Receive Block Errors : 0
Voice/Fax Blocks Transmitted : 0
Voice/Fax Blocks Received : 0
Link Alarms : 0
Remote Downs : 0