Warning, Avertissement – Milwaukee LSM40MP-2 User Manual

Page 26

Advertising
background image

26

NOTE:.DIAGRAMS.&.ILLUSTRATIONS.ARE.NOT.TO.SCALE.

Only doors certified with the appliance

shall be used.

Seules des portes certifiées pour cet

appareil doivent être utilisées.

CAUTION: DO NOT abuse glass door by

striking or slamming shut.

Step 10. BURNER ADJUSTMENTS

Flame Appearance and sooting

Proper.flame.appearance.is.a.flame.which.is.

blue.at.the.base.and.becomes.yellowish-orange.

in.the.body.of.the.flame...When.the.appliance.

is.first.lit,.the.entire.flame.may.be.blue.and.will.

gradually.turn.yellowish-orange.during.the.first.

15.minutes.of.operation..After.15.minutes.of.

operation,.if.the.flame.is.blue,.or.if.the.flame.is.

orange.with.evidence.of.sooting.(black.tip),.the.

air.shutter.opening.may.need.to.be.adjusted.
If. the. air. shutter. opening. is. closed. too. far,.

sooting.may.develop..Sooting.is.indicated.by.

black.puffs.developing.at.the.tips.of.very.long.

orange.flames...Sooting.results.in.black.deposits.

forming.on.the.logs,.appliance.inside.surfaces.

and.on.exterior.surfaces.adjacent.to.the.vent.

termination...

Sooting.is.caused.by.incomplete.combustion.in.

the.flames.and.lack.of.combustion.air.entering.

the.air.shutter.opening..To.achieve.a.warm.yel-

lowish-orange.flame.with.an.orange.body.that.

does. not. soot,. the. shutter. opening. must. be.

adjusted.between.these.two.extremes..

Air Shutter Adjustment Guidelines

•. If.there.is.smoke.or.soot.present,.first.check.

the.log.set.positioning.to.ensure.that.the.

flames.are.not.impinging.on.any.of.the.logs...

If.the.log.set.is.properly.positioned.and.a.

sooting. condition. still. exists,. then. the. air.

shutter.opening.should.be.increased.

•. The.more.offsets.in.the.vent.system,.the.larger.

the.air.shutter.opening.will.need.to.be.

•. An.appliance.operated.with.the.air.shutter.

opened.too.far,.may.have.flames.that.appear.

blue.and.transparent...These.weak,.blue.and.

transparent.flames.are.termed.anemic..

•. Propane.models.may.exhibit.flames.which.

candle.or.appear.stringy..If.this.is.present.

and.persists,.adjust.the.air.shutter.to.a.more.

closed.position,.then.operate.the.appliance.

for.a.few.more.minutes.to.ensure.that.the.

flame. normalizes. and. the. flames. do. not.

appear.sooty..

The.following.chart.is.provided.to.aid.you.in.

achieving. the. correct. air. shutter. adjustment.

for.your.installation.

Air Shutter Adjustment Guidelines

:

Amount of

Primary Air

Flame

Color

Air Shutter

Adjustment

If air shutter is

closed too far

Flame will

be orange

Air shutter

gap should be

increased

If air shutter is

open too far

Flame will

be blue

Air shutter

gap should be

decreased

Top Flange Glass door
assembly

Glass Door Latch (2)

Glass Door Assembly

Firebox Floor

Screws

Installing Glass Enclosure Panel

(see Figure 49)

Retrieve. the. glass. door.. Visually. inspect. the.

gasket.on.the.backside.of.the.frame..Gasket.

surface. must. be. clean,. free. of. irregularities.

and.seated.firmly..

Position.the.door.in.front.of.the.firebox.opening.

with.the.top.of.the.door.held.away.from.the.

fireplace.(Figure 49)...Lower.the.bottom.of.the.

door.assembly.on.the.bottom.door.track.and.

set.on.padded.surface...Pivot.the.door.up.after.

engaging.and.centering.in.the.base.channel.

.

Using.a.Phillips.screwdriver,.fasten.the.door.

frame.to.the.door.latch.with.the.two.(2).screws...

The.latch.should. pull. forward. to. engage. the.

door.frame.

Install.the.door.modesty.shield.on.top.flange.

glass.door.as.follows:..grab.the.door.modesty.

shield. with. both. hands,. with. the. open. hem.

going.down.and.engage.it.with.the.upper.lip.

of.the.glass.door.frame.by.pushing.it.all.the.

way.down...Make.sure.the.installed.shield.is.

firmly.in.place.

With.the.firescreen.hanging.on.the.screen.rod,.

insert.the.right.side.of.the.rod.into.the.existing.

hole.on.the.right.modesty.panel...Bend.down.

the.rod.at.the.center.and.drop.the.left.end.into.

the.slot.on.the.left.modesty.panel,.being.careful.

not.to.scratch.the.paint.

Step 9. INSTALLATION AND REMOVAL

OF GLASS DOOR

Figure 49

INSTALLING THE GLASS DOOR

WARNING

.

When reinstalling the glass

door, the door latch screws

must be securely tightened

to prevent the glass door

from falling out, which could

potentially cause damage and

possible injury.

Do not attempt to substitute the

materials used on this door,

or replace cracked or broken

glass.

Handle this glass with extreme

care! Glass is susceptible to

damage – Do not scratch or

handle roughly while reinstall-

ing the glass door frame.

The glass door of this appli-

ance must only be replaced

as a complete unit as provided

by the manufacturer. Do not

attempt to replace broken,

cracked or chipped glass sepa-

rately.

Do not attempt to touch the

front enclosure glass with your

hands while the fireplace is in

use.

WARNING

Do not operate appliance with

the glass front removed, cracked

or broken.

AVERTISSEMENT

Ne pas utiliser l'appareil si le

panneau frontal en verre n'est

pas en place, est craqué ou

brisé.

Advertising